I recently got a E5 574G-52QU, today I got a new SSD to replace the HDD that came with my laptop. New SSD is a Crucial BX100 (120GB). I cloned the HDD into my SSD with two different programs succesfully, but the SSD failed to boot with both. It booted once, kept working after a few soft reboots until I turned the computer off, then it never booted again. I've tried disabling Secure Boot in the BIOS as well as using Legacy BIOS instead of UEFI, no luck. The SSD is connected to the same SATA port the old HDD was and it's the only drive in the computer, Windows 10 has AHCI support enabled in the registry (I made sure of it before cloning) and the drive is working, tested it on my desktop computer. The BIOS shows no drive at all, if I plug in my HDD instead it boots without problems. SSD firmware is updated to the latest version. I am honestly out of ideas.
↧